TheEnglishman 401 Posted September 9, 2019 Share Posted September 9, 2019 (edited) How do you get these split pin rings out? I can't see a tool that would help. A screwdriver is just going to mash up the housing. It's number 1 in the drawing - it holds the bearing in place, there's one either side - I can't seem to get the picture any bigger Edited September 9, 2019 by TheEnglishman Link to post
DCTPaul 629 Posted September 9, 2019 Share Posted September 9, 2019 (edited) Split Pin Ring... Cant see the pic... Got a link? Circlip? Circlip Pliers... Edited September 9, 2019 by DCTPaul x Link to post
TheEnglishman 401 Posted September 9, 2019 Author Share Posted September 9, 2019 There’s nothing to hold on to. It’s just wire. The YouTube videos are all destructive. Link to post
GaryBee 48 Posted September 9, 2019 Share Posted September 9, 2019 2 fine flat-bladed screwdrivers and a lot of patience? Link to post
DaveM59 1,603 Posted September 9, 2019 Share Posted September 9, 2019 A 20thou feeler blade wedged into the slot close to the end of the wire then a small flat screwdriver to prise the wire up then if you can grab the end with some needle nose pliers lift and rotate it out completely. Link to post
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now