750X 2016 bodywork

[Jondajon 12]

I have just checked out the official Honda instructions for removing the bodywork for the 2016X. Very clear....BUT.... has anyone some good advice for removing the air ducts. Honda just say " remove screw and take air duct off". There are apparantly some plastic catches behind and I am just a bit wary about using brute force and ignorance.

Helpful advice welcome.

Best regards

Jondajon

[CFB 4,602]

If, as I think, it is the same as on the 700, there are 2 reusable plastic fasteners on the inside top edge of the duct. You just press in the centre pin and then they pull out.

To refit, open the two prongs slightly and push the centre pin out of the top of the fitting till it stops, which will allow it to be refitted. push the pin back in to lock in place.