Jondajon 12 Posted June 17, 2016 Share Posted June 17, 2016 I have just checked out the official Honda instructions for removing the bodywork for the 2016X. Very clear....BUT.... has anyone some good advice for removing the air ducts. Honda just say " remove screw and take air duct off". There are apparantly some plastic catches behind and I am just a bit wary about using brute force and ignorance. Helpful advice welcome. Best regards Jondajon Link to post
CFB 4,602 Posted June 17, 2016 Share Posted June 17, 2016 If, as I think, it is the same as on the 700, there are 2 reusable plastic fasteners on the inside top edge of the duct. You just press in the centre pin and then they pull out. To refit, open the two prongs slightly and push the centre pin out of the top of the fitting till it stops, which will allow it to be refitted. push the pin back in to lock in place. Link to post
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now