Bigglesaircraft 293 Posted November 16, 2017 Share Posted November 16, 2017 A little bit of advice required from the Forums experienced members. To test the quality and effectiveness of my antifreeze do I take a sample from the top of the radiator or from the expansion tank/container? Link to post
Rick 236 Posted November 16, 2017 Share Posted November 16, 2017 I would take it from the radiator, although the coolant flows back and forth, I have found some bikes where the expansion tank has been a nice colour and on draining the system the coolant has come out less than perfect, sometimes brown. I would always advise replacing the coolant every two years to be sure of keeping your engine protected both from freezing and corrosion. Remember if you add water it should be distilled/deionised. 3 Link to post
embee 7,288 Posted November 17, 2017 Share Posted November 17, 2017 If in any doubt, just change the coolant. It only holds a couple of lts so trivial cost, it's an easy system to refill, no tricky airlocks etc, just fill slowly at the rad cap and squeeze the hoses a few times while doing so. Ensure the coolant is silicate free as specified in the manual to avoid pump seal wear issues. 3 Link to post
commuter 262 Posted November 20, 2017 Share Posted November 20, 2017 I was always told to take out coolant carefully and gently so as not to oxygenate it, allow it to settle and then, after flushing the system out with a hose, decant 90% of the old coolant gently back into the system adding more antifreeze to top up in place of the sludgy stuff which had been removed. The reasoning behind this is that old coolant has very little dissolved oxygen in it, ( fish would suffocate) : low levels of dissolved oxygen mean that the system is full of stuff which is not able to cause corrosion. Putting nice , fresh water into a system is just about the worst thing to do with a cooling system ( or a heating system ). If you are wondering why old coolant has no dissolved oxygen in it, that is because all of the available oxygen has been used up for rotting away the insides of your cooling system. Clean old coolant is therefore better than freshly made up new coolant. 1 Link to post
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now