Guest smortimer Posted November 14, 2012 Share Posted November 14, 2012 Howdi Does anyone which paddock stand is suitable for the NC700S? I've always wheeled my bike back and forth but now getting so bored of lugging it about I thought I would buy a paddock stand. Any thoughts? Link to post
Guest pw20 Posted November 15, 2012 Share Posted November 15, 2012 My bike is the 700X. I've just bought a Biketek rear paddock stand Series2. It cost £25.59 from Amazon. I believe someone on this forum recommended it but I can't find the thread! I've never had a paddock stand before so I don't know how it compares but it appears to do exactly what it should. Hope this helps. Link to post
Guest Silver Hawk Posted November 15, 2012 Share Posted November 15, 2012 Definitely worth fitting R&G Cotton Reels if you're going to be using a paddock stand a lot of the time. 180917250619 on you-know-where. Link to post
shiggsy 529 Posted November 15, 2012 Share Posted November 15, 2012 Definitely worth fitting R&G Cotton Reels if you're going to be using a paddock stand a lot of the time. Be aware though with that combination you cannot do things like removing the rear wheel, the R&G Cotton reels are dependent on the rear axle being in place. Link to post
Guest Silver Hawk Posted November 15, 2012 Share Posted November 15, 2012 (edited) Definitely worth fitting R&G Cotton Reels if you're going to be using a paddock stand a lot of the time. Be aware though with that combination you cannot do things like removing the rear wheel, the R&G Cotton reels are dependent on the rear axle being in place. Good point! Not very sensible. The Versys has a couple of lugs on the bottom of the square swinging arm especially for cotton reels. Shame Honda didn't do that. Edited November 15, 2012 by Silver Hawk Link to post
tc3 1,095 Posted November 15, 2012 Share Posted November 15, 2012 I got an Oxford OF821 rear stand. Very strong and comes with hooks too (to use on other bikes with bobbins) as well as the cups are lockable in place so that they do not move. Had a cheap stand for years which lasted well but this is a much better piece of kit. Link to post
Guest ColinB Posted November 15, 2012 Share Posted November 15, 2012 I have a Stainless steel Harris stand that uses hooks; which are no use on the X. I made a couple of new supports from 10mm dia. bar and welded a short length of angle bar on each. The angles (with protection) sit each side of the swing arm behind the wheel spindle. Easy to use and interferes with nothing! You can buy a number of paddock stands that just use open angle brackets that adjust in and out - exactly the same as what I fabricated. Link to post
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now