Slowboy 20,538 Posted December 5, 2022 Share Posted December 5, 2022 19 hours ago, MatBin said: Didn't Fortnine do some oil tests? Be good to see your results though Andy. He did but on brand new bikes 2 Link to post
Bostedsprocket 213 Posted December 20, 2022 Share Posted December 20, 2022 On 03/12/2022 at 18:48, Andy m said: You are only trying to blow the bloody doors off compress a square section seal a bit like the washer in a domestic tap. No ten foot bars required. I suspect the line Gorillas gun them on dry. A torque wrench is over kill, (and pointless if the certificate is out of date). The rubber will vary with temperature and how well you beaded it with oil to remove stiction. Better to just go hand tight then give it another flat if it dribbles. The rubber acts like a nylock so it won't undo. I have to say I like the K&N filters with a nut welded on to start with. The Guzzi of course uses a bog roll inner, so no current worries on any of this. Andy I remember reading on K&N'S website that the nut welded on was for removal only not fitting, if over tightened the weld/filter can crack and leak oil, i have never used one myself so don't know how likely that is....... Link to post
davebike 943 Posted December 21, 2022 Share Posted December 21, 2022 Quote I remember reading on K&N'S website that the nut welded on was for removal only not fitting, if over tightened the weld/filter can crack and leak oil, i have never used one myself so don't know how likely that is....... Not that uncommon I seen 3 or4 in the workshop and as we will not sell those with nuts I guess it is easy to overtighten! 1 Link to post
Steve Case 955 Posted December 21, 2022 Share Posted December 21, 2022 Yup that'll be people who have to 'tweak' stuff to make sure it's on properly. From memory it was about 15nm or finger tight. 1 Link to post
DCTPaul 629 Posted December 21, 2022 Share Posted December 21, 2022 The nut on K&N and HiFlo Racing usually have a small hole in the nut for lock wiring... Link to post
bladder 14 Posted December 29, 2022 Share Posted December 29, 2022 changing the filter on the first oil change is very important, the oil and the filter will be contaminated with metal from the bedding in period, and different lubricants the engine builders use, Link to post
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now